Kenwood KDC-X979 CD Player User Manual


 
English
|
27
[2] "PLII"
"MUSIC" (Music) [5] "FINE"
"MOVIE" (Movie)
"MATRIX" (Matrix)
[2] "PNRM"
[3] "DIM"
[4] "CT-WDTH"
[3] "WOW"
"LOW" (Low)
[5] "FINE"
"MIDDLE" (Middle)
"HIGH" (High)
[2] "FOCUS"
[3] "TruBass-F"
[3] "TruBass-R"
"USER" (User) [4] "SRS 3D"
2nd section
Multi-function key operation
Audio control item
[2] "POSI" Position setting
[3] "BL/F" [3] "BL"
[3] "F"
Balance setting
Fader setting
[4] "VOFF" Volume offset
[5] "SW"* [5] "SW LEVEL"
[5] "PHASE"
Subwoofer level
Subwoofer Phase setting
Volume offset: Each source’s volume can be set as a
difference from the basic volume.
* You can control this item when 'Subwoofer Output'
(page 23) is set to "SUB WOOFER ON". Note that you
can control it only when "SP-LEV" is set to any item
other than "None" by 'Audio Setup (Easy mode)'
(page28).
6 Adjust the Audio Control item
Press the [4] or [¢] button.
Each time the button is pressed the setting
switches as shown below.
1st section
Audio Control Item Range
Dolby ProLogic II setting MUSIC/ MOVIE/ MATRIX
SRS WOW setting LOW/ MIDDLE/ HIGH/ USER
OFF setting Through/ Bypass
Panorama setting ON/ OFF
Dimension control R3 — R1/ Neutral/ F1 — F3
Center width control 0 — 7
FOCUS setting OFF/ 1 — 9
SRS TruBass Front setting
SRS TruBass Rear setting
OFF/ 1 — 4
SRS 3D setting OFF/ 1 — 4
2nd section
Audio Control Item Range
Position setting ALL/ Front-L/ Front-R/ Front
Balance setting L15 — R15
Fader setting R15 — F15
Volume offset -8 — 0
Subwoofer level -10 — +10
Subwoofer Phase setting Normal/ Reverse
• The Adjustment item can also be controlled by the
rotary volume knob. Refer to 'Rotary Volume knob
operation mode select' (page 14).
• When the 'Dual Zone System' (page 25) is ON, each of
the following setup is ignored.
- "WOW"/ "PLII"/ "POSI"/ "PHASE"
• WOW: TruBass, FOCUS and SRS 3D are all set to values
shown below.
WOW FOCUS TruBass SRS 3D
HIGH 8 4 4
MIDDLE 6 3 2
LOW 3 2 1
• FOCUS: Adjusts the sound image by changing the
vertical position of the speakers virtually and
increases or decreases the soundscape.
• TruBass: Assisting the playback for the super bass
sound.
• SRS 3D: Making a natural 3D sound field.
• SRS 3D cannot be set in tuner source.
• The Dimension Control can be set only when the rear
speaker is ON.
• The Center Width Control can be set only when the
center speaker is ON.
• Before you set the "TruBass-F"/ "TruBass-R" to get
the best sound, set the speaker size using the 'Audio
Setup (Easy mode)' (page 28) function. Refer to 'Notes
on Sound Management System' (page 12).
7 Exit Audio Control mode
Press the [6] ("RTN") button.