Filter
Top Products
English
|
21
Panel Position Setting
Setting the angle or back-forward position of the
control panel.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "PNL" is
displayed above the [4]/ [5] button.
2 Enter Panel Position Setting mode
Press the [4] ("PNL") (KDC-MP925/X879)/ [5]
("PNL") (KDC-X979) button.
3 Select the item for adjustment
Press the desired [2] — [5] button.
Each time the button is pressed the items that
can be adjusted switch as shown below.
Adjustment Item Button Display
The panel tilts upwards. [2] "ANG–"
The panel tilts downwards. [3] "ANG+"
The panel slides backward. [4] "SLD–"
The panel slides forward. [5] "SLD+"
4 Exit Panel Position Setting mode
Press the [6] ("RTN") button.
• The control panel may be interfered with the shift
lever or another part depending on the angles of the
control panel.
Set the angle to avoid any interference.
• When a hard rubber frame is mounted
Do not use with the panel slid in the forward
direction.
If so, the hard rubber frame will interfere with the
panel when the angle is adjusted downward.
• No sound is produced while the panel is operating.
Theft Deterrent Panel
The Backpanel of the unit can be detached and
taken with you, helping to deter theft.
Removing the Backpanel
1 Turn the ignition OFF or press the [SRC]
button for at least 1 second.
Turn OFF the power, and the control panel
becomes horizontal.
• After the set time passes in 'OFF Wait Time Setting'
(page48), the panel is closed.
2 Remove the Backpanel forward.
When 'DSI (Disabled System Indicator)' (page47)
is set to ON, DSI blinks.
• The back panel is a precision piece of equipment and
can be damaged by shocks or jolts. For that reason,
keep the back panel in its special storage case while
detached.
• Do not expose the Backpanel or its storage case to
direct sunlight or excessive heat or humidity. Also
avoid places with too much dust or the possibility of
water splashing.
Reattaching the Backpanel
1 Set the Backpanel to the panel bracket.
2 Hold down on the Backpanel until it is locked.