Filter
Top Products
English
|
15
Display Mode Switching
Switching the display mode.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [3] (KDC-MP925/X879)/ [4]
(KDC-X979) button.
Refer to 'Notes on Multi-function Key System'
(page 9).
2 Enter display control mode
Press the [3] ("DISP") (KDC-MP925/X879)/ [4]
("DISP") (KDC-X979) button.
3 Select the display mode
Press the [2] ("MODE") button.
Each time the button is pressed the display
mode switches as shown below.
Display Mode Display
"Display:A"
2
3
1
4
1
"Display:B"
6
5
4
"Display:C"
6
5
"Display:D"
6
1 Side graphic part
2 Upper text display part
3 Lower text display part
4 Function item display
5 Text display part
6 Graphic & spectrum analyzer display part
4 Exit display control mode
Press the [6] ("RTN") button.
• No function item is displayed if "Display:C" or "Display:
D" is selected. To use a function item, press any of [1]
to [6] buttons or [NEXT] button. The function item will
be displayed approximately 5 seconds.
• When the 'Dual Zone System' (page 25) is ON, the
spectrum analyzer cannot be displayed.
• The display is dimmed during "Display:B" or "Display:
C" mode.
• The indicator appears only when the Clock is
displayed in the upper or lower position during
"Display:A" mode.
Display:A
Side Graphic Display Switching
Switching the Side graphic Display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [3]/ [4] button.
Refer to 'Notes on Multi-function Key System'
(page 9).
2 Enter display control mode
Press the [3]/ [4] ("DISP") button.
3 Select the display mode
Press the [2] ("MODE") button.
Select the "Display:A" display.
4 Enter display control mode
Press the [4] ("SIDE") button.
"Side Graphic" is displayed.
5 Select the side graphic display
Press the [4] or [¢] button.
Each time the button is pressed the side graphic
display switches as shown below.
Side graphic display
Text + Source
Graphic 1
…
Graphic 3
Spectrum analyzer 1
…
Spectrum analyzer 4
Blank
6 Exit display control mode
Press the [6] ("RTN") button.
•
The setting of this function is available while "Display :
A" is selected for the Display mode.