Filter
Top Products
18
|
English
General features
Display:B/ Display:C/ Display:D
Graphic part/ Spectrum Analyzer
Display Switching
Switching the graphic Display/ Spectrum analyzer
display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [3]/ [4] button.
Refer to 'Notes on Multi-function Key System'
(page 9).
2 Enter display control mode
Press the [3]/ [4] ("DISP") button.
3 Select the display mode
Press the [2] ("MODE") button.
Select the "Display:B"/ "Display:C"/ "Display:D"
display.
4 Select the graphic/ spectrum analyzer
display
Press the [4] ("SA-grph") button.
5 Select the graphic/ spectrum analyzer
display part display
Press the [4] or [¢] button.
Each time the button is pressed the graphic
display/ spectrum analyzer display switches as
shown below.
Graphic display/ Spectrum Analyzer display
Movie 1
Movie 2
*Downloaded movie
Spectrum analyzer 1
…
Spectrum analyzer 5
Wallpaper
• * Function of the KDC-X979
6 Exit display control mode
Press the [6] ("RTN") button.
• The setting of this function is available while "Display :
B"/ "Display:C"/ "Display:D" is selected for the Display
mode.
Display:B/ Display:C/ Display:D
Wallpaper selecting
Select a wallpaper to display when Display Type is
set to "Display:B"/ "Display:C"/ "Display:D".
1 Select the wallpaper display
Refer to 'Graphic part/ Spectrum Analyzer Display
Switching' (page 18).
2 Select the wallpaper
Display the wallpapers one after another
and select one
1 Turn the wallpaper scan ON.
Press the [38] button.
Each time the button is pressed the Wallpaper
scan is turned ON and OFF.
When it’s ON, "SCAN" is displayed.
When it’s ON, each wallpaper is displayed every
several seconds.
2 At the wallpaper you want to display.
Press the [38] button.
Select wallpaper manually
1 Turn the wallpaper scan OFF.
Press the [38] button.
Each time the button is pressed the Wallpaper
scan is turned ON and OFF.
2 Select the wallpaper.
Press the [FM] or [AM] button.
Each time the button is pressed the wallpaper
changes.
3 Exit Display Control mode
Press the [6] ("RTN") button.
Display:B/ Display:C
Text Display Switching
Switching the text display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [3]/ [4] button.
Refer to 'Notes on Multi-function Key System'
(page 9).