Kenwood HM-333 Stereo System User Manual


 
47
Knowledge sections
Important Items
Important Items
1 Remove the CD from the unit.
2 Press the CD 6 key.
3 Wait for some time and verify that the dis-
play becomes as shown in the figure.
4 Wait a few seconds and turn the unit OFF.
Note related to transportation and movement
Before transporting or moving this unit, carry out the
following operations.
Maintenance
Reference
Maintenance of the unit
When the front panel or case becomes dirty, wipe with a
soft, dry cloth. Do not use thinner, benzine, alcohol, etc.
for these agents may cause discoloration.
Do not use contact cleaners because it could cause
a malfunction. Be specially careful not to use con-
tact cleaners containing oil, for they may deform the
plastic component.
In regard to contact cleaner
Condensation (of dew) may occur inside the unit when
there is a great difference in temperature between this
unit and the outside.
This unit may not function properly if condensation oc-
curs. In this case, leave the unit for a few hours and re-
start the operation after the condensation has dried up.
Be specially cautious against condensation in a following
circumstance:
When this unit is carried from a place to another across a
large difference in temperature, when the humidity in the
room where this unit is installed increases, etc.
Caution on condensation Memory backup function
Stored contents which are cleared immediately when
power plug is unplugged from power outlet :
Clock display
Stored contents which are cleared in at least a day after
power plug is unplugged from power outlet :
Amplifier section
"on/standby" status (ON or STANDBY), Last input se-
lection, Volume control value, Tone control levels,
AUX input level, Setting auto power save
Tuner section
Receiving band, Frequency, Preset stations, Auto/
mono setting, Timer setting contents
Cassette deck section
Transport direction, Tape EQ., Reverse mode
Cotton swab
Tape guides
Pinch roller
Head
Capstan
Cleaning the head section
There are precisely aligned
parts around the heads, in-
cluding the tape guides.
When cleaning, pay special attention
so as not to apply shock to them.
Cleaning the heads and peripheral
components
Cleaning the heads and peripheral
components
For maintaining the best condition of
the deck and for longer service life, al-
ways keep the heads, capstan and
pinch roller clean. To clean them, per-
form the following:
1. Open the cassette holder.
2. Using a cotton swab dipped in alco-
hol, clean the head, capstan and
pinch roller carefully.
Demagnetizing the head
When the recording / playback
head is magnetized, the sound
quality will deteriorate. In such a
case, demagnetize the head us-
ing a commercially available de-
magnetizer (head eraser).
CD NO DISC
Note
Note
Note