Filter
Top Products
21
Basic section
Playback of tape
To wind tape at high speed
÷ Press the STOP 7 key to stop fast winding.
÷ The same operation is also available with the 4
and ¢ keys on the main unit.
To fast wind in
direction \
To fast wind in
direction |
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded with Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1 "TAPE EQ." ON
(TAPE equalizer is used)
2 "TAPE EQ." OFF
(TAPE equalizer is not used)
Lit when "TAPE EQ." is ON
÷ Select the "TAPE EQ." ON mode according to the re-
cording condition of the tape.
Selection of reverse mode
To stop playback
The tape counter is set to "0000" when a cas-
sette tape is loaded. By writing down the
counter reading in case you want to interrupt
recording (playback) in the middle of the tape,
the memo will be helpful as a reference for lo-
cating the same position when continuing the
recording (playback) the next time. The tape
counter figure decrements during recording or
playback of the back side (while the 2 tape
transport indicator is lit). To set the tape counter
to "0000", open the cassette holder once. Then
the counter will be reset.
A tip for use of the tape counter
1 Select "TAPE RVS. ?".
2 Select.
3 Set it.
1 "
" : (ONE-WAY)
Only one side is played back (recorded), and then
the tape stops.
2 " " : (REVERSE)
Both sides are played back (recorded), and then
the tape stops.
3 " " : (ENDLESS)
Both sides are played back endlessly. (The tape
stops after recording onto both sides.)
(The initial setting is "
"(REVERSE))
Tape counter display
1 Clock display
2 Tape counter
The displayed information is switched every time the TIME DISPLAY key is pressed.
TAPE EQ.
STOP 7
AUTO/MONO
set
/
demo
(Press the set/demo key while the "?" mark is
blinking)
Main unit only
Remote control unit only
menu
set
/
demo
volume / multi control
\
\
\
\
1
1
TUNING
TIME DISPLAY
÷
PTY
÷
TIME DISPLAY
or
(For other countries)
(For U.K. and Europe)