Kenwood C-707I Stereo System User Manual


 
32
C-707I
Connect a USB  ash memory or the cable of a USB audio
player to the [
USB] port on the front panel of the main unit.
Playing back from a USB device
11
22
This section explains how to play MP3 or WMA audio  les from USB  ash
memory or a USB mass storage class compliant digital audio player.
Also refer to the instruction manual that comes with the USB device you are
connecting.
z
Press the [USBE] key.
The system  nds the MP3 and WMA audio  les on the connected device and
start playback.
See page 38 for the playback sequence when there are multiple folders or
audio  les on the connected device.
Playback does not start if there are no playable MP3 or WMA audio  les on the
connected device.
z
z
This section explains how to connect USB  ash memory or a USB mass storage class compliant digital
audio player to the system and play its MP3 or WMA audio  les.
USB
Before connecting a USB device to the system, turn o both the system and
the USB device.
z
Depending on the connected device, the number of  les, and other factors, reading
of  les can take some time.
If you are using a Kenwood digital audio player, a USB
connection mode selection screen may appear. Select
“Storage Mode” and then press the [USBE] key again.
Do not disconnect the USB device while playback is in progress. Doing so can cause
malfunction.
Never touch the USB device port with your  ngers. Doing so can cause malfunction.
z
z
z
z
USB mode
Storage
Player
en03_c-707i.indd 32en03_c-707i.indd 32 12/19/2007 5:19:57 PM12/19/2007 5:19:57 PM