Filter
Top Products
English
15
Connecting the System
Connecting the speakers
Align the speaker with the main unit so the protrusions in
the main unit enter the installation holes of the speaker.
From the front of the speaker, move it as indicated by the
arrow.
Replacing the speaker cords
If you want to use the speakers while they are detached from the main unit and the speaker cords are too short, you
can replace the supplied cords with the following type of commercially available speaker cords: AWG24-18 (Conductor
Diameter: 0.511 mm - 1.024 mm).
Strip about 1 cm of the vinyl insulation from the tips of both ends of the replacement speaker cords, twist the ends of the
wires together so they do not unravel when you connect them.
Preparing the ends of the speaker cords
Twist the plastic sleeve on the end of the cord as you pull it o .
Notes on connecting the
speaker cords
Never short-circuit the positive (+) and negative (–) ends of the speaker cords.
(Do not touch the + and – cords together.) Mistakenly reversing the positive and
negative polarity will result in unnatural and unclear sound.
Connecting the speaker cords
12 3
en02_c-707i.indd 15en02_c-707i.indd 15 12/28/2007 4:14:39 PM12/28/2007 4:14:39 PM