Filter
Top Products
Channel sweep generator
24
Set standards
B/G, D/K, I, M, Mj, H
▼ W X
+
- +
Set the pre-programmed
channel ranges to be
processed (0…9)
▼
Command to clear spectrum
received by MSK33 (MVG10
tracking)
▼
Enter control printout number
(up to 3 digits), confirm with
"Enter" and run with "Enter"
X
+ +
+ 0…..9
Command to switch a second
MVG10 to stored position
"Recall 0" via MSK33
(MSK33 and MVG10
connected via SCART)
X
+
Command to switch a second
MVG10 to stored position
"Recall 1" via MSK33
(MSK33 and MVG10
connected via SCART)
X
+
Command to switch the
MSK33 video signal from
internal graphics to ext. CVBS.
The respective signals are
relayed to the MVG10 via the
SCART socket for modulation.
X
+
Command to switch the
MSK33 video signal from
ext. CVBS to internal graphics.
The respective signals are
relayed to the MVG10 via the
SCART socket for modulation.
X
+
Store settings in memory at
addresses 0 to 9
▼
Confirm entries
Enter
CSw ControlData
Clear run
CSw ControlData
Prt XXX no run
CSw ControlData
Fkt A 0 no run
CSw ControlData
Fkt A 1 no run
CSw ControlData
Fkt B 1 no run
CSw ControlData
Fkt B 0 no run
CSw Store
nr: 0
ChannelSweep...
Accu 100 %
CSw Standard
B/G
CSw SelRange
……… no run/run