Filter
Top Products
16
It is possible to select your own program (order of tracks being
played) using the program playback mode. Any of the tracks (1-99)
on the CD in the tray of the CD player can be selected.
If you want to program and record tracks, see “Program Edit
Recording” on page 26.
1
Load a CD into the tray of the CD player.
• Only tracks on the CD loaded in the CD player can be registered
into the program (i.e., tracks on a CD loaded in the CDR cannot
be selected for playback).
•“CD READ DISC” will be shown in the information display as
the unit reads the information from each disc.
2
Press the PLAY MODE button when the unit is
in the CD stop mode.
• The CD indicator is shown in the display window, PROG indi-
cator is shown in the display window, and if no program has
been registered, “PG NO PROGRAM” is shown in the informa-
tion display.
• If SET is pressed at this time, programming registration will
start (Step 3).
3
Press the SET button to start program
registration.
• The information display will show the following, and disc
source columns will flash.
4
Select and enter a track number (1-99) by
turning the MULTI JOG control, and then press
the SET button.
• The following is an example of track 2 being entered as Step 1.
• When the SET button is pressed, the programming of Step 1 is
registered, and programming for Step 2 is ready.
5
Repeat Step 4 to program up to a maximum of
32 steps.
• If you try to program over 32 steps, “MEMORY FULL” is
shown in the information display, and the programming func-
tion ends automatically.
• Pressing the CD Control STOP 7 button on the main unit ends
the programming function.
6
Press the CD Control PLAY 3 button to start
programmed play.
• During playback, track number and play time of the track are
shown in the information display.
• The numbers of the tracks that have been played are cleared
from the music calendar. They are displayed again when pro-
grammed play is completed.
• Operation stops automatically when all of the programmed
tracks have been played.
• If the CD Control PLAY
3
button is pressed at a specific step
in a program, the programming function will end and playback
will start from Step 01, not the step currently shown in the infor-
mation display.
To clear a step (track) from the program
To erase a programmed track, turn the MULTI JOG Control while
in the CD stop mode until the track you want to erase is shown in
the information display. Press the CANCEL button to erase the
track from the program. The step number for each track following
the one erased is automatically reduced by one (i.e., steps are
renumbered). To erase the entire program, press the CANCEL but-
ton until “PG NO PROGRAM” is shown in the information dis-
play.
Programming Playback Using
Main Unit Controls
STANDBY
STANDBY/ON
MAXMIN
LEVEL
PHONES
PLAY MODE CD EDIT
REC SOURCE
SELECTOR
CD REC
STOP PLAY PAUSE
REC SOURCE
DIGITAL CD LINE MIC
OPEN/CLOSEOPEN/CLOSE
XL-R2010 CD/CDR MULTIPLE COMPACT DISC RECORDER
CANCELSETMENU
PAUSE
REC/REC MUTING
PLAYSTOP
SYNCHRO
FINALIZE
MULTI JOG/REC LEVEL
+
–
MIX BLANCE
CD
LINE
LINE
MIC
MIC
26
3,4
1 4
Programming step number
Track number
SET
MULTI JOG / REC LEVEL
+
–
1. Select the track. 2. Enter the selection.
Eng.book Page 16 Monday, May 28, 2001 9:46 AM