Filter
Top Products
39
3
Press ADJUST.
The CONTROL buttons now work for sound
adjustments.
4
Press CONTROL ∞ (or 5) repeatedly until one
of the following indications (with the current
setting)
* appears.
REAR L : To adjust the left rear speaker output level
(from –10 to +10).
REAR R : To adjust the right rear speaker output level
(from –10 to +10).
EFFECT : To adjust the DSP effect level. As the number
increases, the effect becomes stronger (normally set
it to “EFFECT 3”).
* “0” is the initial setting for the speaker output levels, and
“EFFECT 3” is for the DSP effect level.
If you have already changed the setting, another setting will be
shown.
5
Press CONTROL 3 (or 2) to make an
adjustment.
• When adjusting the speaker output levels, make adjustments
so that the sound level of the selected speaker is set at the
same level as that of the front speakers.
6
Repeat steps
4
and
5
to make other
adjustments.
To cancel DAP Mode
Press DSP MODE repeatedly so that “STEREO” appears on the
display. The DSP indicator goes off.
CENTER : To adjust the center speaker output level
(from –10 to +10).
REAR L : To adjust the left rear speaker output level
(from –10 to +10).
REAR R : To adjust the right rear speaker output level
(from –10 to +10).
EFFECT : To adjust the DSP effect level. As the number
increases, the effect becomes stronger (normally set
it to “EFFECT 3”).
* “0” is the initial setting for the speaker output levels, and
“EFFECT 3” is for the DSP effect level.
If you have already changed the setting, another setting will be
shown.
5
Press CONTROL 3 (or 2) to make an
adjustment.
• When adjusting the speaker output levels, make adjustments
so that the sound level of the selected speaker is set at the
same level as that of the front speakers.
6
Repeat steps
4
and
5
to make other
adjustments.
To cancel Theatre Surround
Press DSP MODE repeatedly until “STEREO” appears on the
display. The PRO LOGIC and DSP indicators go off.
Using DAP Modes (Front Panel)
A DAP mode cannot be used with another DSP mode. Once one of
the DAP modes is activated, the other DSP mode in use will be
canceled.
• You have to make this adjustment for each source.
• You cannot use the DAP modes if no rear speakers are connected.
1
Select and play stereo analogue software or
Linear PCM digital software.
2
Press DSP MODE repeatedly until one of the
DAP modes appears on the display.
The DSP indicator lights up on the display.
Ex.: When adjusting the left rear speaker output level
Creating Realistic Sound Fields
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
Ex.: When adjusting the center speaker output level
CONTROL
ADJUST
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
ANALOG
SUBWFR
VOL
DSP
LR
LS S RS
(back to the begining)
DSP
MODE
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
EN30-39.RX-E100RSL[B]_4 01.3.7, 8:33 PM39