Filter
Top Products
20
Sound Adjustments
You can also use the remote control for some sound adjustments.
• When using the remote control, see also “Mastering Remote Operations” on page 40.
2
Press CONTROL ∞ (or 5) repeatedly until
“BAL (Balance)” (with the current setting)
*
appears on the display.
* “CENTER” is the initial setting. If you have already changed
the setting, another setting will be shown.
3
Press CONTROL 3 or 2 to adjust the front
speaker balance.
• Pressing CONTROL 3 decreases the left channel output
(from CENTER to L–21).
• Pressing CONTROL 2 decreases the right channel output
(from CENTER to R–21).
CONTROL
DVD STB VCR TV TAPE
FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST
SETTING
STANDBY
DIGITAL
DIGITAL
SURROUND
INPUT
ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND
ON/OFF
DSP
MODE
ANALOG
PRO LOGIC
SUBWFRLFE
SLEEP RDS EON TA STTUNEDINFOHEWS MUTING
MH
Z
KH
Z
VOL
AUTO
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
RX-E100R
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
ADJUST
IC
VOL
T
O
T
Display
CONTROL
5/∞/3/2 INPUT ATT
Attenuating the Input Signal
When the input level of the analogue source is too high, the sounds
will be distorted. If this happens, you need to attenuate the input
signal level to prevent the sound distortion.
• You have to make this adjustment for each analogue source.
Press and hold INPUT ATT (INPUT ANALOG/DIGITAL) so
that the INPUT ATT indicator lights up on the display.
• Each time you press and hold the button, the Input Attenuator
turns on (“ATT ON”) or off (“ATT NORMAL”).
Adjusting the Front Speaker
Output Balance
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speaker output balance.
• You have to make this adjustment for each source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press ADJUST.
The CONTROL buttons now work for sound
adjustments.
INPUT
ANALOG/DIGITAL
INPUT ATT
ADJUST
Remote
NOT
Remote
NOT
ANALOG
MUTI
N
MHZ
KHZ
VOL
INPUT ATT
LR
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
EN20-22.RX-E100RSL[B]_4 01.3.7, 8:33 PM20