Filter
Top Products
19
Basic Settings
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
AUTO1 : When a video component is turned on while the
unit is on, the unit selects the video component as
the source automatically.
AUTO2 : • When a video component is turned on
–while the unit is off, the unit changes the mode
into TV Direct and selects the video component
as the source automatically.
–while the unit is on or TV Direct is activated,
the unit selects the video component as the
source automatically.
• When a video component is turned off
–while TV Direct is activated or the unit is on
with one of the video components selected,
the unit selects the previously selected video
component as the source automatically. (If all
the video components are turned off, the unit
will be turned off automatically.)
MANUAL : Select this to use TV Direct manually.
Note:
When a VCR is selected as the source, AUTO1 or AUTO2 does not
work by turning on the VCR but by starting playback.
2
Press CONTROL ∞ (or 5) repeatedly until
“MODE” (with the current setting)
* appears on
the display.
* “MANUAL” is the initial setting. If you have already changed
the setting, the other mode will be shown.
3
Press CONTROL 3 (or 2) to select “AUTO1”
(or, “AUTO2” or “MANUAL”).
• Each time you press the button, TV Direct mode turns change
as follows:
O
GIC
VOL
A
UTO
A
TT
CONTROL
ON : • If multichannel signals come in, an appropriate
Surround mode will be turned on.
• If Dolby Digital 2 channel or DTS 2 channel
signals come in, “STEREO” will be selected.
• If Linear PCM signals come in, nothing will
change.
OFF : Select this to deactivate Auto Surround.
Notes:
• This function does not take effect in the following cases:
– While playing an analogue source.
– While selecting “DGTL D.D.” or “DGTL DTS” as the fixed digital
input mode (see pages 13 and 14).
• If Surround mode is automatically activated by Auto Surround,
another DSP mode in use will be canceled temporarily. When
multichannel digital signals stop coming in, the selected surround
mode is canceled, and the previous DSP mode resumes.
• If you press SURROUND ON/OFF or DSP MODE with Auto
Surround activated, Auto Surround will be canceled temporarily for
the currently selected source.
Auto Surround setting will be restored in the following cases:
– When you turn off and on the unit,
– When you change the source, and
– When you reset “AUTO SR” to “ON” again.
To cancel Auto Surround
Repeat steps 1 and 2, then select “OFF” in step 3.
Setting the TV Direct mode
You can enjoy switching TV Direct automatically by turning on/off
the video components connected to the unit with SCART cable —
TV Direct auto mode.
• This function takes effect only when the video components and
TV are connected to this unit with SCART cables.
• This function takes effect to the following sources — DVD, STB,
and VCR.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
SETTING
EN10-19.RX-E100RSL[B]_f 01.3.8, 2:50 PM19