Filter
Top Products
16
Basic Settings
SETTING
DVD STB VCR TV TAPE
FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST
SETTING
STANDBY
DIGITAL
DIGITAL
SURROUND
INPUT
ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND
ON/OFF
DSP
MODE
ANALOG
PRO LOGIC
SUBWFRLFE
SLEEP RDS EON TA STTUNEDINFOHEWS MUTING
MH
Z
KH
Z
VOL
AUTO
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
RX-E100R
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
CONTROL
5/∞/3/2 Display
Delay Time — CTR DL, REAR DL
Adjust the delay time of the sounds from the center speaker and
from the rear speakers, comparing to that of the sound from the front
speakers. If the distance to the center speaker and/or the rear
speakers from your listening point is almost the same as that to the
front speakers, select 0 msec.
• 1 msec increase (or decrease) in delay time corresponds to 11
13
/16
inch (30 cm) increase (or decrease) in distance.
2
Press CONTROL ∞ (or 5) repeatedly until
“CTR DL (Center Delay)” or “REAR DL (Rear
Delay)” (with the current setting)
* appears on the
display.
CTR DL (Center Delay) : To adjust the center delay time
(from 0 msec to 5 msec).
REAR DL (Rear Delay) : To adjust the rear delay time
(from 0 msec to 15 msec).
* “0 mS” is the initial setting for the center delay time and
“5 mS” for the rear delay time. If you have already changed
the setting, another setting will be shown.
3
Press CONTROL 3 (or 2) to select the delay
time.
• Each time you press the button, the delay time changes by
1 msec (mS).
4
Repeat steps
2
and
3
to adjust the other delay
time.
2.1 m
2.4 m
2.7 m
3.0 m
Left front
speaker
Right front
speaker
Right rear
speaker
Left rear
speaker
Center speaker
Ex.: In this case, set the center delay to “1 mS” and the
rear delay to “2 mS.”
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
SETTING
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
LCR
LS S RS
LPCM
DOLBY D
DTS
CONTROL
Ex.: When adjusting the center delay
EN10-19.RX-E100RSL[B]_f 01.3.8, 2:50 PM16