Filter
Top Products
Basic settings
To obtain the best possible sound effect from the Surround/
DSP modes (see pages 39 to 44), you need to set up the
speaker and subwoofer information after all the connections
are completed. From pages 29 to 34, how to set speakers and
other basic items of the receiver are explained.
Basic setting items
You can adjust the following items. See pages in parentheses
for details.
• You cannot select the items which is not available with the
current setting. For example, when “S BACK SPK” is set to
“NO,” you cannot select the following items:
S BACK OUT, S BACK DIST, S BACK L DIST, S BACK R DIST
Items To do
SUBWOOFER* Register your subwoofer. (30)
FRONT SPK* Register your front speaker size. (30)
CENTER SPK* Register your center speaker size. (30)
SURROUND SPK* Register your surround speaker size. (30)
S BACK SPK* Register your surround back speaker
size. (30)
S BACK OUT* Register the number of your surround
back speaker(s). (31)
DIST UNIT Select the measuring unit for the
speaker distance. (31)
FRONT L DIST* Register the distance from the left front
speaker to your listening point. (31)
FRONT R DIST* Register the distance from the right
front speaker to your listening point.
(31)
CENTER DIST* Register the distance from the center
speaker to your listening point. (31)
SURR L DIST* Register the distance from the left
surround speaker to your listening
point. (31)
SURR R DIST* Register the distance from the right
surround speaker to your listening
point. (31)
S BACK DIST* Register the distance from the surround
back speaker to your listening point
when using a single speaker for the
surround back speaker. (31)
S BACK L DIST* Register the distance from the left
surround back speaker to your listening
point. (31)
S BACK R DIST* Register the distance from the right
surround back speaker to your listening
point. (31)
Items To do
EX/ES/PLIIx Select the EX/ES/PLIIx reproduction
mode. (32)
DUAL MONO Select the Dual Mono sound channel.
(32)
SUBWOOFER OUT Select sounds emitted from the
subwoofer. (33)
CROSSOVER* Select the cutoff frequency to the
subwoofer. (33)
LFE ATT Attenuate the bass (LFE) sounds. (33)
MIDNIGHT MODE Reproduce a powerful sound at night.
(33)
DIGITAL IN 1 Select the component connected to the
digital coaxial terminal—1(DVR/DVD).
(34)
DIGITAL IN 2 Select the component connected to the
digital optical terminal—2(DBS). (34)
DIGITAL IN 3 Select the component connected to the
digital optical terminal—3(VCR). (34)
AUDIO DELAY Set the audio delay time to correct
synchronization between video and
audio signals. (34)
HDMI SELECT Select the source for HDMI VCR (DBS) IN
terminal. (34)
CMPNT SELECT Select the source for COMPONENT VCR
(DBS) IN jacks. (34)
VIDEO OUTPUT Select the output video signal. (34)
* If you have performed Precise Surround Setup on pages 16
to 18, these settings are not required.
NOTE
Some items above are not available in the following cases below:
– When selecting “A MULTI” for the audio input setting (see page 11)
– When multi-channel PCM signals (see page 41) are coming in with
selecting “HDMI” for the audio input setting (see page 11)
29