Filter
Top Products
Page 51
English
Specifications
Amplifier
Output Power At Stereo operation 120 watts per channel, min. RMS, both channels driven into
8 ohms at 1 kHz with no more than 0.9 % total harmonic
distortion. (IEC268-3/DIN)
At Surround operation
Front Channels 120 watts per channel, min. RMS, driven into 8 ohms at 1 kHz
with no more than 5 % total harmonic distortion.
Center channel 120 watts, min. RMS, driven into 8 ohms at 1 kHz, with no more
than 5 % total harmonic distortion.
Rear channels 60 watts per channel, min. RMS, driven into 8 ohms at 1 kHz,
with no more than 5 % total harmonic distortion.
Total Harmonic Distortion 0.02 %* at 90 watts output
(8 ohms, 1 kHz) (* Measured by JVC Audio Analysis System)
Audio Input Sensitivity/ PHONO (MM) 2.5 mV/47 k ohms
Impedance (1 kHz) CD, TAPE/VCR, TV SOUND, VCR1, 230 mV/47 k ohms
VIDEO1, VIDEO2, DVD (FRONT/
CENTER/REAR/SUBWOOFER)
Audio Output Level TAPE/VCR, VCR1 230 mV
Signal-to-Noise Ratio PHONO 70 dB/66 dB (at REC OUT)
(’66 IHF/DIN) CD, TAPE/VCR, TV SOUND, VCR1, 87 dB/67 dB
VIDEO1, VIDEO2, DVD
Frequency Response (8 ohms) PHONO 20 Hz to 20 kHz (±0.5 dB)
CD, TAPE/VCR, TV SOUND, VCR1, 20 Hz to 20 kHz (±1 dB)
VIDEO1, VIDEO2, DVD
RIAA Phono Equalization ±0.5 dB (20 Hz to 20 kHz)
Loudness Control +6 ±1 dB at 100 Hz
(Volume Control at –40 dB) +4 ±1 dB at 10 kHz
S.E.A. Center Frequencies 100 Hz, 1 kHz, 10 kHz
Control Range ±10 dB ±2 dB
Video
Video Input Sensitivity/Impedance TAPE/VCR, VCR1, DVD, Composite video: 1 Vp-p/75 ohms
VIDEO1, VIDEO2
TAPE/VCR, VCR1, DVD S-video (Y:luminance): 1 Vp-p/75 ohms
S-video (C:chrominance, burst): 0.286 Vp-p/75 ohms
Video Output Level TAPE/VCR, VCR1, MONITOR OUT Composite video: 1 Vp-p/75 ohms
S-video (Y:luminance): 1 Vp-p/75 ohms
S-video (C:chrominance, burst): 0.286 Vp-p/75 ohms
Synchronization Negative
Signal-to-Noise Ratio 45 dB
On-Screen Color System PAL
EN44-52.RX-80P[UF]/f 98.8.31, 1:53 PM51