Filter
Top Products
Page 48
English
Operating Other Manufacturers’ TV
This remote control supplied with the receiver can transmit control signals for other manufacturers’ TVs. By
changing the transmittable signals from preset ones to the other manufacturers’, you can operate the other
manufacturer’s components using this remote control.
When operating the other manufacturers’ components, refer also to the manuals supplied with them.
To operate these components with the remote control, first you need to set the manufacturer’s code for TV.
IMPORTANT
When using the Remote Control, check to see if its remote control mode selector is set to the “TV
/ VCR / TUNER / CD / DVD / VCD” position.
Note:
When you cannot use the remote control though you have preset a correct code to operate the other
manufacturers’ components, try again by following the procedure below.
1. Remove the batteries from the remote control.
2. Press AUDIO POWER once.
3. After one minute or more, insert the batteries to the remote control again.
4. Follow the procedures on this page and the following page again.
If you want to use the remote control to operate JVC’s components, you do not need to follow this step.
To change the transmittable signals for operating another manufacturer’s TV
1. Set the remote control mode selector to the “TV / VCR / TUNER / CD / DVD / VCD” position.
2. Press and hold TV POWER.
3. Press TV SOUND.
4. Enter the manufacturer’s code (three digits) using buttons 1 – 9, and 0.
See the lists on page 49 to find the code.
5. Release TV POWER.
The following buttons can be used for operating the TV (with the remote control mode selector set to
the “TV / VCR / TUNER / CD / DVD / VCD” position):
TV POWER: Turns on and off TV.
After pressing TV SOUND you can perform the following operations on the TV:
CHANNEL +/–: Changes the channels.
TV VOLUME +/–: Adjusts the volume.
1 — 10, 0, +10: Selects the TV channels.
+10 button will function as the ENTER button if your TV requires pressing
ENTER after selecting a channel number.
TV/VIDEO: Sets the input mode (either TV or VIDEO).
Note:
Refer also to the manual supplied with your TV.
6. Try to operate your TV by pressing TV POWER.
When your TV turns on or off, you have entered the correct code.
7. If there are more than one code listed for your brand of TV, try each one until the correct one is
entered.
TV / VCR / TUNER
/ CD / DVD / VCD
SOUND
CONTROL
O
N
S
C
R
E
E
N
C
O
N
T
R
O
L
RM-SR80U REMOTE CONTROL
CD
DISC
VCD
DISC
VCD
CONTROL
VCR
POWER
TV
POWER
AUDIO
POWER
DVD
MULTI
VIDEO1 VIDEO2
TAPE/VCR
VCR1
TV
SOUND
DVD
TEST
(REAR R)
REAR (L)
SEA MODE DAP MODE SURR MODE
FM/AM PHONOCD
546
213
87/P 9
0
+10
10
TV / VCR / TUNER
/ CD / DVD / VCD
MENU
EXIT
MENU
SET
TAPE VCR
CONTROL
VOLUME
CHANNEL
MUTING
FF / ¢
NEXT /
PLAY
SELECT /
STOP
/ REC
TV/VIDEO
TV VOLUME
PAUSE
4 / REW
PREV /
CNTRDELAY
MENU
ENTER
EFFECT
SOUND
CONTROL
FM MODE/MUTINGRETURN
EN44-52.RX-80P[UF]/f 98.8.31, 1:53 PM48