Filter
Top Products
Page 9
English
Video component connections
If your video components have S-video (Y/C-separation) terminals, connect them using S-video cables (not
supplied).
Connecting these video components through the S-video input/output terminals will give you can get better
picture playback quality.
IMPORTANT
This receiver is equipped with both the composite video and S-video input/output terminals for connecting video components.
You do not have to connect both the composite video and S-video terminals.
However, remember that the video signals from the composite video input terminals on the rear are output only through
the composite video output terminals, while the ones from the S-video input terminals on the rear are output only
through the S-video output terminals.
Therefore, if a recording video equipment and a playing video equipment are connected to the receiver through the different video
terminals, you cannot record the picture from the playing equipment on the recording equipment. In addition, if the TV and a
playing video equipment are connected to the receiver through the different video terminals, you cannot view the playback picture
from the playing equipment on the TV.
To view and record the playback picture from the video components connected to the VIDEO1,VIDEO2 and TAPE/VCR jacks,
you must connect the TV and the recording video equipment through the composite video terminals.
Note:
When connecting an audio/video component (ex.: Video CD player) with “karaoke” — singing along — function, use the audio signal attenuating
cord supplied with this receiver. If not, sound may be distorted.
TV connection
GND
RIGHT LEFT RIGHT LEFT
OUT
(REC)
CD
PHONO
VIDEO1
TV
SOUND
OUT
(REC)
AUDIO VIDEO
MONITOR
OUT
To composite video input (See note below.)
To audio output
To S-Video input (for better playback picture quality)
Notes:
• When connecting a JVC TV:
– If you use the AV COMPU LINK remote control system to operate the TV, connect the receiver to the
Video Input 2 jack on the TV.
– If you do not use the AV COMPU LINK remote control system to operate TV, connect the receiver to the
Video Input 1 jack on the TV.
• Use the video components of the PAL color system.
TV
DVD player connection
• When you play back a disc on the DVD player in stereo (or the audio output setting of the DVD player is mixed to two front channels):
DVD
SUBWOOFER
FRONT
DVD
CENTER
IN
(PLAY)
(PLAY)
REAR
OUT
(REC)
TAPE
VCR
IN
(PLAY)
RIGHT LEFT
DVD
DVD player
To front left/right channel audio output
(or to audio mixed output if necessary)
To composite video output
To S-video output (for better playback picture quality)
• When you play back a disc on the DVD player with its analog discrete output mode (5.1 CH reproduction) selected:
DVD
SUBWOOFER
FRONT
DVD
CENTER
IN
(PLAY)
(PLAY)
REAR
OUT
(REC)
TAPE
VCR
IN
(PLAY)
RIGHT LEFT
DVD
To front left/right channel audio output
To subwoofer audio output
DVD player
To center channel audio output
To rear left/right channel audio output
To composite video output
To S-video output (for better playback picture quality)
EN01-25.RX-80P[UF]/f 98.8.31, 1:27 PM9