Filter
Top Products
4
Basic connecting procedure
1 Cut, twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2 Turn the knob counterclockwise.
3 Insert the speaker signal cable.
4 Turn the knob clockwise.
Connecting the front speakers
You can connect two pairs of front speakers (one pair to the FRONT
SPEAKERS 1 terminals, and another pair to the FRONT
SPEAKERS 2 terminals).
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop.
1
AM Antenna Connections
AM Loop Antenna
2
3
4
IMPORTANT:
To obtain the best possible output power from the receiver, and to
prevent the receiver from being overheated, the receiver has the
SPEAKER LOAD SELECTOR which has to be set as follows:
• Set it to “HIGH” when the impedance of the front speakers
connected is within the range of 8 Ω to 16 Ω.
• Set it to “LOW” when the impedance of the front speakers
connected is within the range of 4 Ω to 6 Ω.
Turn the loop until you have the best reception.
Notes:
• If the AM loop antenna wire is covered with vinyl, remove
the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. This could cause poor
reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to
the AM EXT terminal. (Keep the AM loop antenna connected.)
Connecting the Speakers
You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of rear speakers to enjoy the surround effect.
• One center speaker to produce more effective surround effect (to
emphasize human voices).
• One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker
setting information properly to obtain the best possible
Surround and DSP effect. For details, see page 17.
For each speaker (except for a subwoofer), connect the (+) and (–)
terminals on the rear panel to the (+) and (–) terminals marked on
the speakers. For connecting a subwoofer, see page 5.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
ANTENNA
AM
EXT
AM
LOOP
FM 75
COAXIAL
2
3
1
Outdoor single vinyl-covered wire (not supplied)
Left speaker
Left speakerRight speaker
Right speaker
FRONT SPEAKERS 1
FRONT SPEAKERS 2
SPEAKER LOAD SELECTOR
RIGHT LEFT RIGHT LEFT
+
–
CAUTION :
SPEAKER IMPEDANCE
4 6 LOW
8 16 HIGH
FRONT SPEAKERS
1
2
EN01_10.RX-8010V[J]_f 01.1.12, 3:39 PM4