Filter
Top Products
47
AV COMPU LINK Remote Control System
The AV COMPU LINK remote control system allows you to operate JVC video components (TV, VCR, and DVD player)
through the receiver.
This receiver is equipped with the AV COMPU LINK-III, which added a function to operate JVC video components through the video
components terminals. To use this remote control system, you need to connect the video components you want to operate, following the
diagrams below and the procedure on the next page.
CONNECTIONS 1: AV COMPU LINK Connection
VCR 1
DVD player
AV
COMPU LINK III
AV
COMPU LINK
VHS
AV
COMPU LINK
AV
COMPU LINK
EX
DVD
AV
COMPU LINK III
TV
IMPORTANT:
The AV COMPU LINK remote control system cannot control the
DBS tuner connected to the TV SOUND/DBS and DBS component
video terminals, and video components connected to the VIDEO
and VCR 2 terminals on the receiver.
CASE 1 When connecting the source equipment to the receiver using the S-video terminals, connect also this
receiver to the TV’s Video Input 1 terminal using S-video cables.
Note:
If you connect the DVD player and the DBS tuner to this receiver using the S-video terminals, change the video input
terminal setting to "S/C" (see page 16).
When connecting the source equipment to the receiver using the composite video terminals, connect also
this receiver to the TV's Video Input 2 terminal (composite video input) using composite video cables.
Note:
If you connect the DVD player and the DBS tuner to this receiver using the composite video terminals, change the video
input terminal setting to "S/C" (see page 16).
When connecting the source equipment to the receiver using the component video terminals, connect also
this receiver to the TV's Video Input 2 terminals (component video input) using component video cables.
Note:
If you connect the DVD player and the DBS tuner to this receiver using the video component terminals, change the
video input terminal setting to "COMPNT" (see page 16).
CASE 2
To Video Input 1
TV
RX-8010VBK
S-video cable
S-video cable
Source
Equipment
To Video Input 2
(Composite)
TV
RX-8010VBK
Composite
video cable
Source
Equipment
Composite
video cable
Notes:
• When connecting the receiver and a TV with the AV COMPU LINK EX terminal by using a component video cable, you cannot use Automatic
Selection of TV’s Input Mode (see page 48).
• When connecting only the VCR 1 or DVD player to this receiver, connect it directly to the receiver using cables with the monaural mini-plugs.
• Refer also to the manuals supplied with your video components.
CONNECTIONS 2: Video Cable Connection
This receiver is equipped with three types of the video terminals — S-video, composite video, or component video, and the signals coming
into this receiver through one type of video terminals can output only through the same type of the terminal. So you need to connect the VCR
and/or DVD player to the TV using one of the following three ways:
CAUTION:
You can only connect to the TV
with the AV COMPU LINK EX or
AV COMPU LINK III terminal.
DO NOT connect to the TV with
AV COMPU LINK RECEIVER/
AMP terminal.
To Video Input 2
(Component)
TV
RX-8010VBK
Component
video cable
Source
Equipment
Component
video cable
CASE 3
EN47_58.RX-8010V[J]_f 01.1.11, 9:11 PM47