Filter
Top Products
33
English
Regular Play
When the power is already on, you can use this basic procedure:
1. Press down 0 for the deck you want to use.
2. When the cassette holder opens, put a cassette in, with the
exposed part of the tape down, toward the base of the Unit.
• If the cassette holder does not open, turn the power off, then back on and press down 0 again.
3. Close the holder gently.
When both Deck A and Deck B contain a tape, the last deck to have a tape inserted is selected.
To change the selected deck, press DECK A/B. When using the remote control, press TAPE A or
TAPE B.
4. Press TAPE ™ £ on the Unit.
When you use the buttons on the tape control section on the remote control, press 3 for forward
direction playback, or press 2 for reverse direction playback.
COMPU PLAY
When the TAPE ™ £ on the Unit (or 3 or 2 on the Cassette Deck control section on the remote
control) is pressed while the power is on standby, the power is automatically turned on.
If the power is on standby, the power will automatically be turned on.
When “TAPE” appears on the display, the tape play starts toward the direction currently selected.
To stop playing, press 7 STOP on the Unit (or 7 on the Cassette Deck control section on the remote
control).
To remove the tape, stop the tape, and press down 0.
To change deck while playing a tape, press TAPE ™ £ after pressing DECK A/B on the Unit or
press 3 or 2 after pressing TAPE A or TAPE B on the tape control section on the remote control.
To change the direction of a tape while it is playing, press TAPE ™ £ on the unit (or
3 or 2 on the Cassette Deck control section on the remote control).
Fast Left and Fast Right ——————————————————
While the tape is stopped, press 1 on the MULTI CONTROL and the tape will wind rapidly to the
left side of the cassette without playing.
While the tape is stopped, press ¡ on the MULTI CONTROL and the tape will wind rapidly to the
right side of the cassette without playing.
Note: Deck A and Deck B cannot be used for playback at the same time.
Music Scan
To find the beginning of a music track during play, use the Music Scan function. Music Scan searches
blank portions that usually separate selections, then plays the next selection.
Finding the Beginning of the Current Selection —————
Press 1 or ¡ on the MULTI CONTROL during play.
Make sure that you press 1 or ¡ on the MULTI CONTROL in the opposite direction to that in
which the tape is playing. Searching stops at the beginning of the current selection, and the current
selection starts automatically.
Finding the Beginning of the Next Selection ———————
Press 1 or ¡ on the MULTI CONTROL during play.
Make sure that you press 1 or ¡ on the MULTI CONTROL in the same direction as that in
which the tape is playing. Searching stops at the beginning of the next selection, and the next
selection starts automatically.
Music Scan works by detecting a 4-second long blank at the beginning
of each selection, so it will not work well if your tape has • • •
• No blank at the beginning of a selection.
• Noise (often caused by much use or poor quality dubbing) which fills the blank with noise.
• Long, very soft passages or pauses in a selection. The scan will detect these as 4-second long
blanks. If this happens, just scan again until you reach the selection you want.
or
TAPE
or
TAPE
TAPE A TAPE B
NEXT
PREV
EN32-38.CA-V908T[U]/f 98.7.22, 8:08 PM33