Filter
Top Products
17
English
Getting Ready to Use Dolby 3 Channel
Logic
Speaker Arrangements for Dolby 3 Channel Logic ————
Setting-up Dolby 3ch Logic ————————————————
Perform the steps below using the buttons on the remote control.
1. Press and hold SHIFT B during following procedures.
2. Press 3CH LOGIC (2).
When using the Unit, press PRO LOGIC/3CH LOGIC to select 3CH LOGIC (2).
Each time you press the button, Dolby Surround programs change as follows:
= PRO LOGIC = 3CH LOGIC = (previous sound mode) = (back to the beginning)
• When you select Dolby Surround, Sound Mode (see page 11) is canceled.
3. Select the desired Center Speaker mode.
Press CENTER MODE (6). Each time you press the button, Center Speaker modes change as follows:
= NORMAL = WIDE = OFF = (back to the beginning)
4. Set the volume to the level you like.
5. Press TEST TONE (3).
A test tone comes out of the speakers in the following order:
• When “OFF” is selected for Center Speaker mode, no test tone comes out of the center speaker.
= LEFT = CENTER = RIGHT = (back to the beginning)
6. Adjust the level for the center speaker.
Press CENTER LEVEL + (5) or – (4). Set the level so that it is about
the same as the level from the front speakers.
• You cannot adjust the level for the center speaker if “OFF” is selected for Center Speaker mode.
7. Press TEST TONE (3) again.
Test Tone mode is canceled.
This completes the preparations required for using Dolby 3 Channel Logic.
• You cannot adjust the Delay Time or rear speaker levels in Dolby 3 Channel Logic mode.
8. Release SHIFT B.
Using Dolby Surround
1. Press PRO LOGIC/3CH LOGIC and select the desired mode.
If you are using the remote control, press PRO LOGIC (1) or 3CH LOGIC (2) while pressing SHIFT
B. Make sure that the center speaker and rear speakers have been set up correctly.
2. Playback as source with the mark.
Enjoy the great sound achieved through Dolby Surround.
To cancel Dolby Surround
Press PRO LOGIC/3CH LOGIC until the Dolby Surround indicator goes out. If you are using the remote
control, press the Dolby Surround buttons (PRO LOGIC (1) or 3CH LOGIC (2)) while pressing SHIFT B.
TV
Front
Speaker
Front
Speaker
Center Speaker
3CH LOGIC
CENTER MODE
TEST TONE
CENTER
LEVEL
–+
TEST TONE
3CH LOGIC
or
PRO LOGIC
SHIFT B
or
SHIFT B
EN14-20.CA-V908T[U]/f 98.7.22, 8:04 PM17