JVC LVT0865-004A Home Theater System User Manual


 
11
Getting Started
Connecting the FM and AM (MW) antennas
Make sure the antenna conductors do not touch any other terminals, connecting cords, and power cords. This could cause
poor reception.
7 AM (MW) loop antenna
VIDEO
S-VIDEO
VIDEO OUT
ANTENNA
DISP.SET
AUX
TO SP-PWV70
IN
AC IN
AV
COMPU
LINK
AM
COAXIAL
75
AM
R
L
HV
FM
EXT
LOOP
DIGITAL IN
OPTICAL
RGB Y / C
AV OUT
AV
1
2
3
If the antenna cord is covered with vinyl, remove the
vinyl by twisting it as shown.
7 FM antenna
Turn the loop until you
have the best
reception.
If reception is poor:
Connect an outdoor single vinyl-
covered wire to the AM EXT
terminal with keeping the AM
(MW) loop antenna connected.
Connecting AM (MW) loop antennaSetting up AM (MW) loop antenna
Attach the AM (MW) loop to its base by snapping the tabs on the loop
into the slot in the base.
NOTES:
Disconnect the supplied FM Antenna before attaching a 75
coaxial connector (the kind with a round wire going to an outdoor antenna).
We recommend that you use a coaxial cable to the FM antenna, since it is well-shielded against interference.
Connecting the supplied FM antenna
Extend the supplied FM antenna horizontally.
If reception is poor:
Connect an outdoor FM antenna
with the standard type (coaxial)
connecter.
Outdoor FM antenna
(not supplied)
Outdoor FM antenna cord (not supplied)
Outdoor single vinyl-covered wire (not supplied)
AM (MW) loop
antenna
Wire
Press and hold the
terminal clamp.
Insert the antenna cord.
Release the finger from
the clamp.
Center unit
EN1-20TH-V70R[B]1 02.3.12, 6:32 PM11