Filter
Top Products
54
Using the Cassette Deck (Recording)
Things to Know Before You Start Recording ——————————————
❏ It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs
without the consent of the owner of copyright in the sound or video recording, broadcast or
cable programme and in any literary, dramatic, musical, or artistic embodied therein.
❏ Press the DOLBY B NR button — the indicator lights up — to reduce tape hiss.
❏ When you want to record onto both sides of a tape, turn on the auto reverse mode. However,
recording automatically stops after recording in the ¤ direction with the auto reverse mode on.
Therefore, make sure that the tape direction is ‹ when recording with the auto reverse mode
on.
❏ The recording level is automatically set correctly, so it is not affected by the VOLUME control.
Thus, during recording you can adjust the sound you are actually listening to without affecting
the recording level.
❏ Two small tabs on the cassette tape, one for side A and
one for side B, can be removed to prevent accidental
erasure or re-recording. To record on a cassette with the
tabs removed, you must cover the holes with adhesive
tape first. However, when a type II tape is used, only
cover part of the hole as shown, since the other part of
the hole is used to detect the tape type.
❏ When recording, you can hear Sound Modes through the speakers or headphones. However, the
sound is recorded without Sound Modes (see page 9).
❏ Type I and Type II tapes can be used for recording.
Note: The first and end portions of the tape are called leader tape, which cannot be recorded onto.
When you start recording, the first part of the recording may not be done because of this
leader tape. Before inserting the cassette, first wind the leader tape.
CAUTION: If recordings you have made have excessive noise or static, the unit may be too close to
a TV which has been on during recording. Either turn off the TV or increase the distance between
the TV and the CA-MD9R.
PHONES
DOLBY B NR
CD RECREC PAUSE
AUTO REVERSE
DOLBY B NR
AUTO TAPE SELECTOR
¤ ‹ (Play)
7 (Stop)
IMPORTANT: Before using the Remote Control for the
tape operations, set the Remote Control to the tape
operation mode by pressing the TAPE button.
REC PAUSE
CD REC
DOLBY B NR
EN.51-72.CA-MD9R[B]/F 98.2.13, 0:20 PM54