Filter
Top Products
3
Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below
Pairing?
Yes: Press VOL
No:
Press BACK
Pairing?
Device:
Passkey: XXXXXX
A
[Device name]
“XXXXXX” is a 6-digit passkey randomly
generated during each pairing.
Operate the Bluetooth device to confirm
the passkey.
Ensure that the passkey which appears
on the unit and Bluetooth device is the
same.
Select “Yes” to confirm the passkey.
Pairing?
Yes: Press VOL
No:
Press BACK
Pairing?
Device:
[Device name]
B
You can change to a desired PIN code before
pairing. (' page 30)
(2) If only “Pairing” appears, operate the
Bluetooth device to confirm pairing.
(1) When the Bluetooth device prompts
you to key in a PIN or passcode, enter the
PIN code “0000” into the Bluetooth
device. The above should then appear on
the display.
Select “Yes” to confirm the pairing.
After pairing is successful, “Pairing COMPLETED” appears on the display.
The unit will establish a connection with the newly paired Bluetooth device and you can then control
the Bluetooth device through the unit.
“” will light up when a phone is connected.
“” will light up when an audio device is connected.
Once the connection is established, the device is registered to the unit and there is no need to
perform the pairing again unless you delete the registered device.
Some Bluetooth devices may not be able to connect to the unit after pairing. Connect the device to
the unit manually. Refer to the instruction manual of the Bluetooth device for more information.
Connecting/Disconnecting a registered device manually
To connect
1
(Hold)
-<Bluetooth>
-<Phone>/<Audio>
-<Connect>
2
Select <Connect>.
“Connecting...” appears on the display when the
unit is connecting to the device.
“Connected”#“[Device Name]” appears on the
display when the device is connected.
3
Select the desired device.
4
Press MENU to exit.
To disconnect
1
(Hold)
-<Bluetooth>
-<Phone>/<Audio>
-<Disconnect>
2
Select <Disconnect>.
“Disconnected”#“[Device Name]” appears on the
display when the device is disconnected.
3
Select the desired device.
4
Press MENU to exit.
Bluetooth
ா
connection
16
|ޓENGLISH
2011/12/30ޓ15:27:57KW-R900BT_J_EN