Filter
Top Products
References
To clean the disc
\,ripe the disc with a soft cloth in a straight line
from center to edge.
• HandlingDiscs • DO NOT use any solvent -- such as
conventional record cleaner, spray,
thinner or benzine -- to clean the disc.
• Remove the disc from its case by holding it at
the edge while pressing the center hole lightl}_
• Do not touch the shi W surface of the disc or
bend the disc.
• Put the disc back in its case after use to
prevent warping.
• Be careful not to scratch the surfhce of the disc
when placing it back in its case.
• Avoid exposure to direct sunlight, temperature
extremes and moisture.
• Cleaning the system
• Stains on the systenl should be wiped off with a soft cloth. If the
system isheavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean with a
dry cloth.
• Since the system may deteriorate in qualit)%become damaged or
get its paint peeled oft, be careful about the fbllowing.
-DO NOT wipe it with a hard cloth.
-DO NOT wipe it fbrcefull)_
-DO NOT wipe it with thinner or benzine.
-DO NOT apply aW volatile substance such as insecticides to it.
-DO NOT allow any rubber or plastic toremain in contact with it
lbr a long time.
PROBLEM POSSIBLE CAUSE SOLUTION
Power does not come on. The power cord and/or system cord is not connected. Connect the power cord and system cord correctly (See
pages 10 and 11.)
The remote control does The batteries are exhausted, Replace the batteries. (See page 7.)
not work. Sunlight is shining directly on the remote sensor Hide the remote sensor from direct sunlight.
No sound. The system cord and/or speaker cord is not connected. Check the connection.
The attdio cord is not connected to AUX IN (VCR) and/ Connect the cord correctly. (See page 1i,)
or DIGITAL IN (DBS) correctly.
An incorrect source has been selected. Select the correct source. (See page 15.)
No picture is displayed The video cord is not connected correctly. Connect the cord correctly. (See page i0.)
on the TV screen. The disc or file is not playable. Use a playable disc or file. (See pages 3 and 4.)
No picture is displayed The scan mode is set to "480p" though the center unit is Change the scan mode to "480i". (See page 16.)
on the TV screen, the connected to the TV which does not support the
picture is blurred, or the progressive video input such as a conventional TV
picture is divided into
two parts.
Video and attdio are The disc is scratched or dirty. Replace or clean the disc.
distorted. A \rCR is connected between the center unit and the Connect the center unit and TV directl)c (See page 10.)
TXg
The picture does not fit The monitor type is not set correctly. Set "MONITOR TYPE" properl)c (See page 34.)
the TV screen.
Hard to listen to Antennas are disconnected. Reconnect the antennas correctly and securely. (See
broadcast because of page 8.)
noise.
38