Filter
Top Products
Connections [ Donotconnectthepowercorduntilallotherconnectionshavebeenmade. ]
Tu obtain the best possible sound from this system, you need to
place all the speakers except the subwoofer at the same distance
from the listening position.
Centerspeaker
/
/
Powered
subwoofer
Surround left "'. -" Surround right
speaker " " speaker
If your speakers cannot be placed at the same distance from the
listening position
Yuu can adjust the delay time of the speakers. See "Delay menu
(DELAY)" on page 34.
NOTE
• Place the satellite speakers on a fiat and level surfhce.
• The front and center speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, they may cause
color distortions. So, pay attention to the tbllowing when installing
the speakers.
When placing the speakers near a TV set, turn offthe TV's main
power switch or unplug it befbre installing the speakers. Then wait
at least 30 minutes befbre turning on the TV's main power switch
again.
Some TVs may still be aflbcted even though you have fbllowed the
above. If this happens, move the speakers away from the TV.
• The surround speakers are not magnetically shielded.
If they are located nearby the TV or monitor, it will probably cause
color distortion on the screen. To avoid this, do not place the speakers
nearby the TV or monitor.
• Be sure to place the powered subwoofer to the TV's right. Ifyou place
the powered subwoof_r to the TV's let}, keep sufficient distance
between them to prevent the TV screen from appearing mottled.
• Yuu can get better picture quality in the order -- Component
video > S-video > Composite video.
• Distortion of picture may occur when connecting to the TV via a
VCR, or to a TV with a built-in VCR.
• Yuu need to set "MONITOR TYPE" in the PICTURE menu
correctly according to the aspect ratio of your T\( (See page 34.)
• ToconnectaTVequippedwith thecomponentvideoinput
jacks
• If ?_ur TV supports progressive video input, you can enjoy a high
quality picture by setting the progressive scan mode to active.
(See page 16.)
Center unit
TV
Y p p_
roeomponentt' 4"
video input
Component video cord (not supplied)
NOTE
• If the component video input jacks of your TV are of the BNC type,
use a plug adapter (not supplied) to convert the pin plugs to BNC
plugs.
• The component video signals can be output only when you select
DVD or USB MEMORY as the source to play. (See page 15.)
• ToconnectaIV equippedwiththecompositeorS-videojacks
Center unit
Composite video cord (supplied)
Align the • marks. ort
S-video cord 1
(not supplied)
To S-video input To composite
video input
Center unit System cord
(supplied)
Align the • marks.
Powered
subwoofer
Align the • marks.
10