Filter
Top Products
Operatingexternalcomponentswith the remote control
I The buttons described below are used on 12 and 13. I
I
pages
DBS
VCR --
Number
buttons
TV RETURN--
ENTER
®®
®®
@®
VCWDBS
0/I VCR/DBS
...... B OIl TV
33//
: TV ,OEOo
II..m -- CH +/-
loo+
Remote
control mode
selector
RE(
TV VOL
TVVOL+_
II
(play button)
NOTE
• Manufhcturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.
4
Press number buttons (1-9, O) to enter
the manufacturer's code (2 digits)•
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
Manufacturer Code Manufacturer
Jvc 01" Samsung
Hitachi 10 Sanyo
Magnavox 02 Sharp
Mitsubishi 03 Sony
Pmlasonic 04, 11 Toshiba
Philips 15 Zenith
RCA 05
Code
12
13, 14
O6
O7
O8
O9
5
*"01" is the initial setting.
Release ©/I TV.
If there is more than one code listed for corresponding brand,
try each one until yon enter the correct one.
• Operation
Aim the remote control at the T\L
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The %llowing buttons are available:
©/I T_k Turns TV on and oK
TV VO L +/-: Adiusts the volume.
TV/VIDEO: Selects the input mode (either TV or
VIDEO).
CH +/-: Changes the channels.
1-10, 0, >>10 (100+): Selects the channel.
TV RETURN: Alternates between the previously selected
channel and the current channel.
NOTE
• The operating buttons may dii}i:rdepending on manufhcturers.
• Tosetthemanufacturer'scode
7 Slide the remote control mode selector
to TV.
2 Press and hold ©/I TV.
Keep the button pressed until step 4 is finished.
3 Press ENTER.
• Tosetthemanufacturer'scode
Slide the remote control mode selector
to VCR/DBS.
2 Press DBS.
3 Press and hold ©/I VCR/DBS.
Keep the button pressed until step 5 is finished.
4 Press ENTER.
Continued on the next page
12