Filter
Top Products
– 7 –
2
1
1
If cords are covered with insulation, twist the core of
the cord at the end of each cord, then remove the
insulation.
2
Connect the AM (MW/LW) loop antenna to the AM
LOOP terminals as illustrated.
3
Turn the AM (MW/LW) loop antenna until you have
the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
The AM (MW/LW) loop antenna must remain connected.
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM (MW/LW) antenna
AM (MW/LW) loop antenna
(supplied)
Connecting Speakers
You can connect the speakers using the speaker cords.
Use only speakers with the same speaker impedance—more
than 4 Ω—as indicated by the speaker terminals on the rear of
the unit.
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Insert the end of the speaker cord into the terminal
as illustrated.
Match the polarity of the speaker terminals: (+) to (+)
and (–) to (–).
• DO NOT connect or disconnect the speakers while
the unit is turned on.
• DO NOT connect more than one speaker to one
speaker terminal.
3
2
1
Vinyl-covered
wire
(not supplied)
Right speaker
Left speaker
Black
Red
Black
Red
Black
Speaker
cord
Red
Red
Black
White
White
EN01-09_NXHD10R[B]f.pm6 02.6.24, 8:57 AM7