Filter
Top Products
– 58 –
You can assign titles during play or recording
• During play:
Entering a track title
The MD recorder repeats playback of the current track until you
press ENTER in step
6
above. When you press ENTER, the next
track will be played.
Entering a disc title
The MD recorder repeats playback of all tracks of the MD until
you press ENTER in step
6
above. When you press ENTER, the
MD recorder enters the track title entry mode.
Entering a group title
The MD recorder repeats playback of the tracks in the group
until you press ENTER in step
6
. When you press ENTER, the
MD recorder enters the next group title entry mode.
• During recording:
Entering a track title
The MD recorder continues recording even after you press
ENTER in step
6
above. When you press ENTER, a track title is
assigned to the track where you have started the title entry. If
you do not press ENTER before recording ends, the track title
assigned will be canceled.
• During CD Synchronized Recording (see page 36):
You can assign the disc title, and 16 track titles one after another
as recording goes on. The track titles you have entered are
automatically assigned to the tracks recorded on the MD in
sequential order. If you enter 17th track title or more, they are
ignored.
When you unplug the AC power cord or if a power
failure occurs before step
8
The editing you have made is not recorded on the MD.
Available symbols are as follows:
Changing the Title
You can make a correction or change the title.
1
Follow steps
1
to
4
on page 56.
2
Select the character you want to correct, by pressing
or .
• Make sure that the character you want to change is
flashing.
3
Press CANCEL to delete the character you have
selected in the above step.
4
Input the correct character, referring to step
5
on
the previous page.
5
Repeat steps
2
to
4
of the current procedure to
correct more characters.
6
Press ENTER to finish correcting the title.
• If you want to correct another title, select another title
entry mode by pressing
or , press SET, then
repeat from step
2
above.
• If you want to finish the correction, go to the next
step.
7
Press MD 0 on the main unit to eject the MD.
“WRITING” and the MD REC indicator flash while
the editing you have made is being recorded on the
MD.
To erase all the characters, press CANCEL repeatedly in
step
3
above to erase all the characters, then go to step
6
.
(Blank)
EN56-58UX-Z7MD[A]f 02.7.31, 21:2958