JBL Home Theater System Home Theater System User Manual


 
CUSTOM SETUP
FRONT L/R 80Hz
CENTER 80Hz
SIDE L/R 80Hz
REAR L/R 80Hz
SUBWOOFER 80Hz
THX ULTRA2 SUB OFF
BGC N/A
ASA APART
SETUP
SDP-5
3-29
CENTER FULL, 30Hz to 120Hz, THX 80Hz, NONE
Opens the CENTER SPEAKER menu shown above, which can be
used to select a crossover point for the Main Zone audio output
connector labeled Center. When set to FULL, the SDP-5 sends a full-
range audio output signal to this connector. Otherwise, the SDP-5
activates a crossover point at the selected setting. Choose the
setting closest to the low-frequency rating of the associated
speaker. When set to NONE, the SDP-5 redirects center channel
signals to the Main Zone audio output connectors labeled
Front L/R.
CENTER
CUSTOM SETUP
SPEAKERS
SETUP
Note:
When the CENTER parameter is set to NONE, center
channel signals will not be redirected if the 5.1a
BYPASS listening mode is activated. To redirect center
channel signals, configure the speaker setup with the
associated DVD-A/SACD player.
. . . Custom Speaker Setups continues on page 3-30
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
SETUP

SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGER
LOCK OPTIONS
SPEAKERS
SPEAKER SETUP
CUSTOM SETUP
SYNTHESIS 7CH SETUP
SPEAKER DISTANCES
LEVELS CALIBRATION
80Hz 80Hz
80Hz 80Hz 80Hz
80Hz 80Hz
80Hz
L
M
SUB
R
C
SL
SR
RL
RR
CUSTOM SETUP
CENTER 80Hz
CENTER SPEAKER
FULL
30Hz
40Hz
50Hz
60Hz
70Hz
80Hz
THX 80Hz
90Hz
100Hz
110Hz
120Hz
NONE