Filter
Top Products
User Manual M2
34
LISTENING TO THE RADIO
1. Press the STANDBY/ON button to turn the unit ‘ON’.
2. Press TUNER/BAND repeatedly to select the AM or FM band
3. Tune to the desired station as follows:
• Manual Tuning
Repeatedly press the SCAN/TUNING or buttons until the display shows the exact fre-
quency of the desired station. Use the Manual Tuning method to tune to weak or distant stations
that are not strong enough to be recognized by the Automatic Tuning system.
• Automatic Tuning
Depress and hold the SCAN/TUNING or buttons until the display begins to move, then
release the buttons. The Tuner will search up or down the band for the next strong signal and
stop on that station. Repeat this procedure until the tuner stops on your desired station.
Tuner Functions
To Receive FM Broadcasts in Stereo
Press the REPEAT/FM MODE button on the remote until AUTO ST appears on the display. If the FM
stereo broadcast signal is weak, press the REPEAT/FM MODE button until FM MONO appears on
the display. Background noise will be reduced but the signal reproduced will be mono.
To restore stereo reception, press the REPEAT/FM MODE button again.
Presetting Stations in the Tuner Memory
You can store up to 80 of your favorite stations (40 FM / 40 AM) in the tuner memory for easy
recall at any time.
• Auto Preset Station Memory
The device automatically searches for and saves the rst stations it receives on the FM and AM
bands.
1) Press TUNER/BAND repeatedly to select the AM or FM band
2)
Press the A-MEMO button on the remote twice. AUTO MEM will appear
on the display.
3) Press ENTER to conrm and begin searching.
4) The unit will store up to 40 AM and 40 FM stations automatically.
ST
PRGM
m m
AU TO S T
ST
F
m m
O N O