Filter
Top Products
Troubleshooting and Removal/Replacement Procedures
3–3
H/W Path Class Description
============================================
bc
8 bc I/O Adapter
8/0 ext_bus GSC built-in Fast/Wide SCSI Interface
8/0.0 target
8/0.0.0 disk QUANTUM LPS1080WD
8/0.5 target
8/0.5.0 disk DEC DSP3210SW
8/0.6 target
8/0.6.0 disk DEC DSP3210SW
8/12 ba Core I/O Adapter
8/12/5 ext_bus Built-in SCSI
8/12/5.3 target
8/12/5.3.0 tape HP C1537A
8/12/5.4 target
8/12/5.4.0 disk SEAGATE ST3600N
8/12/5.6 target
8/12/5.6.0 disk MICROP 2112
10 bc I/O Adapter
10/12 ext_bus GSC add-on Fast/Wide SCSI Interface
10/12.4 target
10/12.4.0 disk SEAGATE ST31200W
Checking the Hardware Installation
Perform the following steps to check the hardware installation:
CAUTION: The DDS-3 drive is susceptible to mechanical and electrostatic
shock. When handling the drive, always wear the static strap that
came in the DDS-3 drive kit. Always handle the drive carefully.
1. Check that the SCSI-2 terminator is connected to the single-ended SCSI-2 port on
the rear I/O panel of the system unit (if there are no external SCSI-2 devices), or
that the last external single-ended SCSI-2 device is terminated.