Introduction
1–6
Preparing to Install a New DDS-3 Drive
The following information describes how to prepare the DDS-3 drive for installation.
Tools Required
The following tools are needed to install the DDS-3 drive:
• #2 Phillips screwdriver
• Small needlenose pliers
• T10 torx wrench
Verifying Kit Contents
Verify that the kit contains one of each of the following:
• DDS-3 drive (part number 0950–2650) and bezel.
• Set of 4 screws (M4x6)
• Power adapter cable
• Set
of two expansion
brackets and four screws (M3x6 T10)
(not included in all kits)
• SCSI I/O cable
• Static strap
• HP DDS-3 T
ape Drive User
’
s Guide
(A1658–90702)
NOTICE: If any contents of your kit are missing, contact your sales
representative.
Operating System Support
The HP DDS-3 drive supports HP-UX 10.01 and later. This drive requires patches
PHSS_7894 (or equivalent replacement) for support of the Support T
ools Manager
, and
patch PHSS_7583 (or equivalent replacement) for offline SCSI testing..