Filter
Top Products
Introduction
1–11
Preparing the System
Perform the following steps to prepare the system for the DDS-3 drive installation:
1. Determine the existing SCSI-2 address settings currently in use on your system by
completing the following steps.
2. Enter the following at the prompt:
/usr/sbin/ioscan
RETURN
After a few moments the ioscan utility lists all of the SCSI I/O devices it could find.
The list appears similar to the following:
H/W
Path Class Description
============================================
bc
8 bc I/O Adapter
8/0 ext_bus GSC built-in Fast/Wide SCSI Interface
8/0.0 target
8/0.0.0 disk QUANTUM LPS1080WD
8/0.5 target
8/0.5.0 disk DEC DSP3210SW
8/0.6 target
8/0.6.0 disk DEC DSP3210SW
8/12 ba Core I/O Adapter
8/12/5 ext_bus Built-in SCSI
8/12/5.3 target
8/12/5.3.0 tape. HP C1537A
8/12/5.4 target
8/12/5.4.0 disk. SEAGATE ST3600N
8/12/5.6 target