Filter
Top Products
14
MAIN REMOTE CONTROL FUNCTIONS
Light: Press to illuminate the buttons on the remote. Press it
again to turn the back light off, or wait 10 seconds after the last
button press for the light to turn off on its own.
Disc Menu: While a DVD is playing, press the DVD Source
Selector, then this button, to display the disc’s menu.
Soft Keys: These buttons are used to select sources A, B, C
and D (see note on page 13), or for other functions with some
source devices. See Table A14 in the appendix for details. They
are also used with a Teletext-capable television if your broadcast,
cable or satellite provider offers Teletext service.
Volume Control: Press to raise or lower the volume.
Mute Button: Press to mute the AVR 7550HD’s speaker and
headphone outputs. To end the muting, press this button, adjust the
volume, or turn off the receiver.
Channel/Page Control: When the tuner has been selected,
this control changes the station. When using The Bridge II or a USB
drive, this control allows you to scroll a page at a time through a
long list of content. While operating a cable, satellite or HDTV set-
top box or a television, press these buttons to change channels.
Transport Controls: These buttons are used to control
source playback.
Record Button: Use this button to make recordings when
an audio or video recorder is in use.
AVR Settings/Remote Menu Button: Press to
display the AVR’s Main Menu, or to switch the remote to AVR device
mode. Press and hold for 3 seconds to access the menu for the
remote control. The menu commands and options will appear in
the LCD Display.
The functions are: program the codes for a device, learn codes
for an individual key, change the device type of a selector, program
an activity (macro), program punch-through functions for channel
control or transport control, rename a device or a key’s function,
change the brightness of the back light, reset the remote to its
factory-default status, or exit the remote menu. See the Initial
Setup section for details on programming the remote, and see
the Advanced Functions section for further information.
Info Settings Button: Press to display the AVR’s Info Menu,
which contains the settings for the current source.
Source Settings Button: Press a Source Selector and
then this button to display a source device’s settings menu.
Sleep Settings Button: Press to activate the sleep timer,
which turns off the receiver after a programmed period of time of
up to 90 minutes. Each press decreases the timer by 10 minutes,
ending with the “Sleep Off” message.
Zone Selector: Use this switch to select whether AVR commands
will affect the main listening area (Zone 1) or the remote zone of a
multizone system (Zone 2). For normal operation, leave the switch
in the Zone 1 position.
AVR 7550HD OM.qxd 2/25/09 11:52 AM Page 14