Filter
Top Products
39
2.9.2. Audio
Audio In and Audio out are reserved for future Development
Note: If Sirius Satellite Radio control and functionality is desired in the future, be sure to
use the Audio Outputs on the Sirius Receiver (BBWX1) itself and not from an MFD!
2.10. MFD8/12 Video, USB and Audio Connection
The DVI, USB, Analog Video Input and Audio In/Out ports are behind the connector
cover on the rear panel. To access to the ports and connect the cables, please refer to
the instructions below. Note that these connection points require an optional waterproof
connector boot if necessary. These connection points are not a waterproof design
without this option. Any water egress in this area will not be covered by the limited
warranty.
Note: The Waterproof Connector Boot is only required if the DVI, USB or Audio
connections are used and waterproofing is necessary for the MFD’s location.
2.10.1. Waterproof Connection
Waterproof connections for the DVI, USB, Analog Video Input and Audio I/O ports
require the optional connector boot (Type: OP19-7, PN: 001-028-090).
Note: This option will not be available until October 2008. Furuno apologizes if this
delay causes any inconvenience with respect to installations
Content of Waterproofing Kit
1. Unfasten the four screws to remove the connector cover at the rear of the display
unit.