Filter
Top Products
16
1.2.2. MFDBB Processor Bulkhead Mounting
Mark four fixing holes positions on the bulkhead. Screw in two 6x30 self-tapping screws
at upper fixing positions, leaving 5 mm protruding. Set the processor unit to the screws
and screw in two self-tapping screws at lower positions. Tighten all screws.
1.2.3. MDBBB Keyboard Mounting
The BlackBox keyboard (control unit MCU-001) is designed to be flush mounted in a
console or panel.
1. Prepare a cutout in the mounting location using the template sheet (supplied) for
the MCU-001.
2. Remove the front panel from the MCU-001 by grasping it at its sides and pulling
it towards you.
3. Attach the mounting gasket (sponge) to the MCU-001.
4. Fix the MCU-001 by using four self-tapping screws (supplied).
5. Attach the front panel to the MCU001