Filter
Top Products
DVI DL 201 Tx/Rx • Installation
Installation, cont’d
2-4
Under-desk mounting
The gure below shows how to mount the DVI DL 201 Tx under
a desk or podium, using the optional Extron MBU 123 under
desk mounting kit (PN 70-212-01). To mount the
DVI DL 201 Rx, the optional Extron MBU 125 under desk
mounting kit (PN 70-077-01, not shown) must be used. For
either unit, follow these instructions:
1. Remove rubber feet if these have been installed on the
bottom of the unit.
2. Secure the mounting brackets to the unit, using the four
4-40 screws provided (see the gure below).
Under-desk mounting the DVI DL 201 Tx
3. Hold the unit with the brackets attached against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4. Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" (6.3 mm) deep in the mounting surface at the marked
screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" (6.3 mm) of the screw head protrudes.
6. Guide the mounting screws through the slots in the
brackets and place the unit tight against the surface.
7. Slide the unit slightly in or out so that it is held in place
by the screws; tighten all four screws to secure the unit in
place (see the gure above).