Filter
Top Products
DVI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-20
DVI 201 Tx/Rx • Installation and Operation
2-21
OUTPUT
Tx
Rx
RS-232
PASS THRU
DVI
AUDIO OUT
DVI 201 Rx Front Panel
DVI 201 A D Rx Front Panel
DVI 200 Rx Series
RS-232
PA SS THRU
Tx Rx
12
12
9
13
Figure 2-17 — DVI 201 Rx front panel connectors
h
Receiverinputconnector— Connect one end of the two
separate TP cables from the transmitter output connectors (item
f
on page 2-17) to these RJ-45 female connectors.
C
Do not connect these devices to a computer data or
telecommunications network.
N
In order to fit in the junction box, the TP cables and
RJ-45 connectors should not have a boot installed.
N
Connect transmitter output 1 to receiver input 1.
Connect transmitter output 2 to receiver input 2.
N
Ifnecessary,testforpropercableconnection(output1to
input 1, output 2 to input 2) as follows:
1. Plug both TP cables into the powered unit.
2. Momentarilyconnecteitherofthecablesonthe
opposite end into the unpowered unit‘s “2” connector.
If the unpowered unit’s Power LED is lit, the
connection is correct.
If the unpowered unit’s Power LED is not lit,
unplug the connector on the unpowered end and
connect the other cable to the “2” connector.
N
Extron recommends 28AWG to 24AWG TP cable for the
RJ-45 connectors.
See "TP cable termination," on page 2-23, to properly wire the
RJ-45 connectors.
i
DVIOutputconnector— Connect a DVI monitor or projector
for display of the transmitted direct digital image. See "DVI
connector pin assignments," on page 2-22, for pin assignments.
j
AudioInputconnector(DVI201ADRx[Decora]only)—
Connect one end of a 5-wire audio cable to this 3.5 mm, 5-pole
direct insertion connector.
Connect the free end of the same cable to any compatibly
wired audio source unit, such as a switcher's output or a
DVI 201 A D Tx (Decora) transmitter.
Figure 2-18 shows how to wire the captive screw audio
connector. Insert the wires into the appropriate openings in the
direct insertion connector. Tighten the screws on the side to
fasten the wires.
Tip
Sleeve
Sleeve
Tip
Unbalanced Input Balanced Input
Do not tin the wires!
Sleeve (s)
Tip
Tip
Ring
Ring
L
AUDIO
OUTPUT
R
L
AUDIO
OUTPUT
R
Figure 2-18 — Captive screw connector wiring for
receiver audio output
k
DCpowerinputconnector — Plug the included external
12 VDC power supply into either this connector or the power
input connector on the transmitter (item
e
on page 2-17). See
"Power supply wiring," on page 2-25, to wire the connector.