Filter
Top Products
Installation Manual 23
I/O Wiring – Model 2400S PROFIBUS-DP and DeviceNet Transmitters
Power Supply I/O Wiring – DP and DNI/O Wiring – ANBefore You Begin Power Supply I/O Wiring – DP and DNI/O Wiring – ANBefore You Begin Power Supply I/O Wiring – DP and DNI/O Wiring – ANBefore You Begin Power Supply I/O Wiring – DP and DNI/O Wiring – ANBefore You Begin
4.4 I/O wiring for Model 2400S DeviceNet transmitters
Connect the transmitter to the DeviceNet segment according to the diagram in Figure 4-3. The
transmitter is shipped with a DeviceNet male sealed Micro Connector (Eurofast) that has been
preinstalled and wired according to the DeviceNet specification.
Follow all local safety regulations.
A transmitter that has been improperly wired or installed in a hazardous area could cause an explosion.
Make sure the transmitter is wired to meet or exceed local code requirements. Install the transmitter in
an environment that complies with the classification tag on the transmitter.
Figure 4-3 Model 2400S DeviceNet I/O wiring
➯
Attach a 5-pin female
Eurofast connector here