Filter
Top Products
Installation Manual 7
Transmitter Orientation and Power Supply
Power Supply I/O Wiring – DP and DNI/O Wiring – ANBefore You Begin
Figure 2-2 Rotating the user interface module on the transmitter
2.5 Power supply requirements
Model 2400S Analog and Model 2400S PROFIBUS-DP transmitters can accept either AC or DC
power. The transmitter automatically recognizes the source voltage. Power supply requirements are:
•AC power:
- 85–265 VAC
-50/60 Hz
- 4 watts typical, 7 watts maximum
•DC power:
- 18–100 VDC
- 4 watts typical, 7 watts maximum
The Model 2400S DeviceNet transmitter is powered from the DeviceNet network per the DeviceNet
specification. There is no need to connect separate power-supply wiring for the Model 2400S
DeviceNet transmitter. Skip to Chapter 4.
4 × Transmitter
housing cover screws
(captive)
2 × User interface
screws (captive)
Transmitter housing
cover
User interface module
* Transmitter with aluminum housing shown.
Procedure for stainless steel housing is similar.