Filter
Top Products
14 Micro Motion
®
Model 1700 and 2700 Transmitters
Installing the Transmitter
Figure 2-7 Remote core processor – Wall mount or pipe mount
To mount the core processor:
1. Identify the components shown in Figure 2-8. For dimensions, see Appendix A.
2. If desired, reorient the core processor housing on the bracket.
a. Loosen each of the four cap screws (4 mm).
b. Rotate the bracket so that the core processor is oriented as desired.
c. Tighten the cap screws, torquing to 30 to 38 in-lbs (3 to 4 N-m).
3. Attach the mounting bracket to an instrument pole or wall. For pipe mount, two user-supplied
U-bolts are required. Contact Micro Motion to obtain a pipe-mount installation kit if required.
Figure 2-8 Remote core processor components
Mounting bracket
(wall mount)
Mounting bracket
(pipe mount)
End-cap
Mounting bracket
Core processor lid
Core processor housing
Conduit opening
for 4-wire cable
Conduit opening
for 9-wire cable
4 × Cap screws (4 mm)