Filter
Top Products
E L A N H O M E S Y S T E M S
Page 66 © ELAN Home Systems 2009 • All rights reserved.
DT22 INSTALLATION MANUAL
dd = ST, R1, R2, S1, S2
Function:
Begins saving the current station to a preset.
&DT,R1,PRESET,SAVE<cr> Preset number is specified using the DIGIT and ENTER command.
&DT,R1,DIGIT,1<cr>
&DT,R1,DIGIT,0<cr>
&DT,R1,ENTER<cr>
Current station is saved to current group’s preset 10.
If two digits are given, ENTER is not required.
&DT,R1,PRESET,SAVE<cr>
&DT,R1,DIGIT,1<cr>
&DT,R1,DIGIT,7<cr>
Current station is saved to current group’s preset 17.
Sending ENTER without any digits will save to the first open preset.
&DT,R1,PRESET,SAVE<cr>
&DT,R1,ENTER<cr>
Timeout is 5 seconds. Preset WILL be saved in case of timeout.
&DT,R1,PRESET,SAVE<cr>
&DT,R1,DIGIT,3<cr>
Wait 5 seconds...
Current station is saved to current group’s Preset 3.
Send CANCEL or any other command to prevent saving of preset.
&DT,R1,PRESET,SAVE<cr>
&DT,R1,DIGIT,1<cr>
&DT,R1,CANCEL<cr>
No preset is saved.
Command:
&DT,dd,PRESET,SAVE,mm<cr>
dd = ST, R1, R2, S1, S2
mm = 1 - 99
mm = 0 will save to the first available preset.
Function:
Saves the current station to a given preset on currently active group.
Send Group command first to save to a specific group.
Command:
&DT,dd,PRESET,DELETE<cr>
dd = ST, R1, R2, S1, S2
Function:
Begins deleting the current tuned preset.
ENTER command is required to delete.
If no preset is tuned, nothing is deleted.
&DT,R1,PRESET,DELETE<cr>
&DT,R1,ENTER<cr>