Filter
Top Products
E L A N H O M E S Y S T E M S
© ELAN Home Systems 2009 • All rights reserved. Page 19
DT22 INSTALLATION MANUAL
AM Loop Antenna
DT22
AM Loop Antenna
The AM antenna is connected to the terminals marked AM/GND. These connections are not polarity sensitive, so it
does not matter which wire is connected to the GND or AM terminals.
To prevent unwanted noise, place the antenna as far away as possible from other electronics, speaker cords, power
cords and amplifiers.
FM Antenna
Indoor FM Antenna
Connect the included FM antenna to the FM (coaxial) jack. Generally, a T-type twin lead antenna will be sufficient; if
you live in an area where the FM signals are particularly weak, it may be necessary to install an outside or rooftop
antenna.
If standard FM broadcast frequencies are available via your cable service, you may connect your 75 ohm FM anten-
na jack to your cable system. Please contact your cable service to discuss this option.
DT22-240
REAR PANEL
F-JACK
F-CONNECTOR