Filter
Top Products
E L A N H O M E S Y S T E M S
Page 62 © ELAN Home Systems 2009 • All rights reserved.
DT22 INSTALLATION MANUAL
Function:
Sets DEFAULT state of unsolicited feedback to the RS232 port to on.
Whenever power is turned off and on, unsolicited data is set to On if this command was sent to the DT22 prior to
turning off.
Use UFB On/Off command if unsolicited data needs to be changed during operation.
Unsolicited feedback is always On for Ethernet by default.
Command:
&DT,CH,CONFIG,RS232,UFB,OFF<cr>
Function:
Sets DEFAULT state of unsolicited feedback to the RS232 port to off.
Whenever power is turned off and on, unsolicited data is set to Off if this command was sent to the DT22 prior to
turning off.
Use UFB On/Off command if unsolicited data needs to be changed during operation.
Unsolicited feedback is always On for Ethernet by default.
Query:
&DT,CH,CONFIG,RS232,UFB,?<cr>
Function:
To query the state of unsolicited feedback.
Response:
*DT,CH,CONFIG,RS232,UFB,ON<cr>
or
*DT,CH,CONFIG,RS232,UFB,OFF<cr>
UFB On/Off (Unsolicited Feedback)
Command:
&DT,CH,UFB,ON<cr>
Function:
Turns on unsolicited feedback for the RS232 port if this command was received from the RS232 port.
Turns on unsolicited feedback for the Ethernet port if this command was received from the Ethernet port.
Command:
&DT,CH,UFB,OFF<cr>
Function:
Turns off unsolicited feedback for the RS232 port if this command was received from the RS232 port.
Turns off unsolicited feedback for the Ethernet port if this command was received from the Ethernet port.
Query:
&DT,CH,UFB,?<cr>
Function:
Queries the unsolicited feedback state during operation.
Default state of unsolicited feedback for RS232 is controlled by config value.
Default state of unsolicited feedback for Ethernet is ON.