Filter
Top Products
14
2 Connecting an optical fiber cable (commercially available) to the digital audio input connector (OPTICAL)
Line up in proper direction
Remove the dust cap, line up the cable in the proper directly, then
insert it securely as far as it goes.
NOTE:
• Store the dust cap in a safe place, and be careful not to
lose it.
When not using the terminal, attach the cap to protect the
terminal from dust.
CH SEL
ENTER
(4) Connecting to a AV amplifier with a built-in decoder
When DVDs recorded in Dolby Digital or DTS are played, Dolby Digital or DTS bitstream signals are output from the DVD player’s digital
audio output connectors. If a Dolby Digital or DTS decoder is connected, you can achieve sound with the power and sense of presence
of a movie theater or concert hall.
DVD-A1XV
Digital audio input connector
(OPTICAL)
Digital audio input connector
(COAXIAL)
AV amplifier with a built-in decoder
(AV control center)
Optical fiber cable
(commercially available)
75Ω/ohms pin-plug cable
(commercially available)
(or)
NOTE:
• Some discs contain copy prohibit signals. If such discs are played via a VCR, the copy prohibit system may cause disturbance in
the picture.
• Set the “TV TYPE” in “VIDEO SETUP” in “SETUP” to comply with your TV’s video format. When the TV is PAL formated, set to
PAL. (See pages 43, 44.)
(3) Connecting to a TV with 21-pin SCART Terminal
Use the commercially 21-pin SCART cable to connect the TV’s 21-pin SCART terminal to the DVD-A1XV’s 21-pin SCART terminal (AV1).
DVD-A1XV
21-pin SCART terminal
TV
•To improve picture quality, you can change the video signal output from the AV1 terminal from “Video” to either “S-Video” or “RGB”
to suit the type of television you are using (See page 45.).
Dust cap
NOTE:
• Harsh noise that could harm your ears or damage the speakers is generated when a DVD recorded in DTS is played while using
a decoder, etc., that is not DTS-compatible.