Filter
Top Products
3
ENGLISH
ENGLISH
(2) INSTALLATION
Please set up DN-HS5500 horizontally.
(3) INSTALLING THE 7” RECORD ADAPTOR
Your own 7” vinyl record can be installed on this product by using the provided adaptor.
This original design grants you the freedom to use your favorite vinyl record for that ultimate analog turntable feel.
*Make sure the record used is flat and not warped.
• 7” record adaptor accessories
q Adaptor (2).............................................................1
w Screw (
< head) .....................................................3
e Fixing Plate............................................................1
NOTE:
Depending on the RECORD you choose, friction with
the Slipmat may not be enough, which can cause an
undesired drag sound.
If so, use a different record that’s thicker or heavier.
1. Set Adaptor (2) in the hole of 7” record.
2. Fix Plate with 3 screws. (< head).
3. Insert D hole of the Adaptor (2) on the D shaft of the
Motor.
4. Insert the Adaptor (1) on the Adaptor (2).
Screw (< head)
Fixing Plate
7” record
Adaptor (2)
Fig. 1
Fig. 2
7” Record
Adaptor (2)
Adaptor (1)
Slip Mat
Adaptor (1)
2
INSTALLING THE PLATTER, THE SCRATCH DISC AND THE
SLIPMAT
(1) INSTALLING THE PLATTER, THE SCRATCH DISC and THE SLIPMAT
• Accessories
1. Install the Platter on the taper boss of the motor.
2. Install the Slip Mat on the Platter.
3. Insert D hole of the Scratch Disc on the D shaft of the
Motor.
NOTE: The printed face is located on the Slip Mat side.
4. Insert the Adaptor according to the direction of the
arrow.
NOTE: Please note the direction of insertion.
q Aluminum Platter...................................................1
w Scratch Disc...........................................................1
e Slip Mat..................................................................1
r Adaptor (1).............................................................1
Scratch Disc
(Groove side
DOWN)
D shaft
Slip Mat
Platter
Taper Boss
(Motor Unit)
Fig. 1
Scratch Disc
Fig. 2
Fig. 3
Adaptor (1)
CAUTIONS:
• Do not touch the motor unit.
• Do not turn on the power without the Platter being
mounted.
NOTE:
Please note the position of Platter when you move DN-
HS5500 after Platter is set.