Filter
Top Products
53
ENGLISH
• The included remote control unit can be used to turn the power to the standby mode after a maximum of 120 minutes. (Sleep timer)
• Use this function to automatically switch the power to the standby mode after a specific amount of time (minutes).
Example: To set the power to the standby mode in 50 minutes according to the clock. Be sure to correct the current time setting.
(1) Setting the sleep timer (remote control unit only)
1
Select and play the desired function.
2
Press the SLEEP button.
• “120” is displayed and the “SLEEP” indicator flashes.
Remote control unit
12 0
The display switches as follows each time the SLEEP
button is pressed:
90120 60 50 3040 20 10
3
When the “SLEEP” indicator is flashing, press the SLEEP
button again until “50” is displayed.
• “50” is displayed and the “SLEEP” indicator flashes.
Remote control unit
5 0
• After 4 seconds, the display returns to as it was before the
sleep timer was set, and the “SLEEP” indicator stops
flashing, remaining lit. (This completes the sleep timer
setting.)
4
The power is set to the standby mode 50 minutes later.
To turn the sleep timer off, press the SLEEP button repeatedly until
the “SLEEP” indicator turns off. The sleep timer can also be
turned off by press the power button on the main unit or the
remote control unit to turn the entire system’s power to the
standby mode.
“SLEEP” indicator off
Main unit Remote control unitRemote control unit
2, 3
14
USING THE SLEEP TIMER
• Operate the remote control unit at the “AMP” position.
Set the remote
control selector
switches
Switch1 to DVD
Switch2 to AMP