Filter
Top Products
31
ENGLISH
4
Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
• The volume can be adjusted within the range 0 to 60. Note
that depending on the input signal, surround mode, speaker
settings and channel level setting, it may not be possible to
adjust the volume up to 60.
5
Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
Main unit
+
-
Remote control unit
The volume level is
displayed on the
display.
• “DIG” lights when digital signals are input properly. If “DIG” is
flashing, check whether the connections are proper and whether
the input component’s power is on.
Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
One of these lights, depending on
the input signal.
Lit
Input signal display
• DOLBY DIGITAL
• DTS
• PCM
Input mode when playing CD sources
• When playing CDs containing recordings of live concerts, etc., in
the “AUTO” mode, the sound may be slightly broken at the
beginning. If this happens, switch to the “PCM” mode.
Input mode when playing DTS sources
• If DTS-compatible CDs are played in the “PCM” mode, noise is
output because DTS playback is not possible.
To play a DTS-compatible source, be sure to set the input mode
to “AUTO” or “DTS”.
• Noise may be generated at the beginning of playback and while
searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.
Main unit
2 To check the currently playing program source, etc.
Press the MENU/SET button. Display “STATUS” then press
the select
0
and
1
control.
The current program source and surround settings are shown
on the display each time the button is pressed or turned.
G DI IT DLA DV
Main unit